Keep your thermal labels away from direct sunlight or high heat, as they will turn black.
Follow these steps to ensure the hardware is correctly configured before installing any software. Ipiel-la3 Manual
Before diving into the setup, here are the core capabilities of your device: Direct Thermal (No ink or toner required) Resolution: 203 DPI Max Printing Speed: 150mm/s Supported Paper Width: 1.57" to 4.1" (40mm - 104mm) Keep your thermal labels away from direct sunlight
The printer will move the labels back and forth to sense the gap. Once it stops, your calibration is complete. 4. Driver Installation Once it stops, your calibration is complete
Connect the power adapter to the printer and plug it into a grounded outlet.
Pull a small amount of the first label out past the tear-off bar and close the lid firmly. Turn the switch at the back to the "On" position. 3. The "Smart Label Identification" (Calibration)
The Ipiel-la3 needs to learn the size of your labels to avoid skipping pages. Ensure the printer is ON . Press and hold the top FEED button . Wait until you hear one beep , then release immediately.