Smartctl Open Device Dev Sda Failed Dell Or Megaraid Controller Please Try Adding 39d Megaraid N 39 Extra Quality ^hot^ May 2026

When running smartctl on a Dell PowerEdge server or any system using a MegaRAID (LSI/Broadcom) controller, you often encounter this error: Smartctl open device: /dev/sda failed: Dell or MegaRAID controller, please try adding '-d megaraid,N' .

You cannot guess this number, as it doesn't always start at 0. Use the storcli (or older MegaCli ) utility to find the (Device ID). Command : sudo storcli /c0 /eall /sall show When running smartctl on a Dell PowerEdge server

To bypass the virtual layer, you must tell smartctl which specific physical disk you want to inspect by providing its (represented as 1. Find the Physical Device ID ( Command : sudo storcli /c0 /eall /sall show

: Locate the DID column in the "Drive Information" table. If your disk is in slot 1 and has a DID of 11 , then 2. Run the Correct smartctl Command Run the Correct smartctl Command Once you have

Once you have the ID, run the command against the controller's device node (usually /dev/sda or /dev/bus/0 ). Cannot get smartctl working - Unix & Linux Stack Exchange

This happens because the operating system sees a (the RAID array), but smartctl needs to talk directly to the physical disks hidden behind the controller. The Solution: Using the -d megaraid,N Flag