Ts1162 Installation Manual [extra Quality] May 2026

Choose a flat, solid, vertical surface to prevent the base from warping when tightened.

The is a 3-LED Remote Arming Station (RAS) designed for use with Challenger security systems. Rated at IP67 , this robust keypad is suitable for both indoor and outdoor installations, including harsh, dusty, or wet environments.

Pull the bottom of the body away from the base and lift it off the top tabs. ts1162 installation manual

Test the keypad by entering a valid user code to arm/disarm the assigned areas.

The Challenger system identifies each keypad by its unique RAS address, which must be set manually before the unit is powered up. Choose a flat, solid, vertical surface to prevent

Once physically installed and addressed, the keypad must be enabled within the Challenger system programming: Access the (Default code: 4346 ). Navigate to the RAS Configuration menu. Enable the specific RAS address you assigned to the TS1162.

For environments where the keypad face may become worn, a replacement TS1162-LABEL (membrane) is available to restore the unit's appearance and button legibility. Pull the bottom of the body away from

Use the internal DIP switches (usually 1–4) to set the RAS address (1 through 16). Refer to your specific Challenger panel manual for the binary address table.