Set the "Fuses." For most VCDS clones, the standard fuse bits are: Low: 0xCD High: 0x19
0xFF (Note: These may vary depending on the specific loader version you are using.) Step C: Flash the Firmware Load the Flash (.hex) file into the buffer. Load the EEPROM (.eep) file into the buffer. Click Write/Program . Verify the write was successful. Step D: FTDI Configuration (If Necessary) vcds atmega162 reflash
Open your VCDS cable casing (usually held by 4 screws under the sticker). Identify the chip. Set the "Fuses
You want to move from an older firmware (like 1.92) to a newer one (like 1.96) to support more recent car models. Verify the write was successful
Updating the VCDS software on your PC while using a clone cable often results in the software "killing" the cable's firmware.