Manual |best| — Xh-m608

Relay closes when voltage ≥ P2 (upper limit) and opens when voltage ≤ P1 (lower limit). Setting the Limits (P1 & P2)

The XH-M608 acts as an intelligent switch. It does not provide power itself; it controls the connection between a power source (charger) or a load and your battery.

The module uses a menu system (P0 to P3) to define its behavior. Use the button to navigate and the + / – buttons to adjust values. P0: Operating Mode Selection Xh-m608 Manual

Sets the trigger for starting a charge or stopping a discharge.

Relay closes when voltage ≤ P1 (lower limit) and opens when voltage ≥ P2 (upper limit). Relay closes when voltage ≥ P2 (upper limit)

Connect the positive (+) and negative (–) leads of your 6-40V battery to the module's battery input terminals.

The is a versatile DC 6-40V battery charge and discharge controller module designed for real-time voltage monitoring and automated protection . Whether you are managing a solar bank, an electric vehicle battery, or a DIY power station, this manual provides the essential steps for wiring, programming, and operating the device safely. 1. Technical Specifications The module uses a menu system (P0 to

Set a value from (minutes) to enable a timed charge or discharge session. 4. Advanced Functions & Troubleshooting ainow.inhttps://ainow.in XH M608 Battery Charge And Discharge Module - AINOW