Xnx Universal Transmitter Quick Start Guide -
Use the integrated mounting lugs to secure the unit to a wall or pipe. Ensure the sensor is pointing downward to prevent water or dust accumulation. Wiring: Open the housing using the provided hex key.
Mount the transmitter in an area where gas is likely to accumulate, keeping it away from direct heat sources or high-vibration areas.
Follow the wiring diagram for your specific output (4-20mA, HART, or optional Modbus/Fieldbus). Xnx Universal Transmitter Quick Start Guide
The XNX uses a non-intrusive interface. You do not need to open the housing to navigate menus; simply use the on the four sensors located around the display: Left/Right: Navigate through menu options. Enter (Checkmark): Confirm a selection. Escape (X): Go back or cancel. 5. Quick Calibration Steps
By following these steps, you can ensure your XNX Universal Transmitter provides reliable gas detection and keeps your workplace safe. Use the integrated mounting lugs to secure the
Ensure the unit is properly grounded to prevent EMI interference. 3. Powering Up
Only qualified personnel should perform installation and calibration. Mount the transmitter in an area where gas
Remove the gas and exit the menu to return to monitoring mode. 6. Common Fault Codes Sensor missing or disconnected. F161: Calibration required or failed. W001: Warning that the unit is in "Inhibit" mode. Safety Warnings
