Xycd60 Manual May 2026

Avoid running continuous loads right at the 10A limit to prevent the relay from overheating.

Double-check the "IN" (Power Source/Load) and "BAT" (Battery) terminals. Reversing polarity can damage the module. xycd60 manual

for about 3 seconds to enter the parameter setting interface. Short press SET to cycle through the parameters: UP : Upper limit voltage. dn : Lower limit voltage. OP : Conduction time (00:00 to 99:59, or "----" to disable). dOP : Delayed conduction time (0–999 seconds). FOP : Forced start time (0–10 seconds) in discharge mode. Use UP/DOWN buttons to adjust the values. Press and hold SET again to save and exit. Voltage Percentage Calculation Avoid running continuous loads right at the 10A